BadgerWheel TORque Box Battery Enclosure

from $269.99

This is a TORque box enclosure with screws.
If ordering with a tail light install, please allow 1-2 days for install. Tail lights are installed by trimming the excess holding tabs in the rear, and the 22-LED length strip is adhered in with 3-4 small dabs of clear epoxy. This creates a strong hold that is reliable, and still allows full light transmission through the box window. More information in the link below.

Add Tail Light?:
Quantity:
Add To Cart

This is a TORque box enclosure with screws.
If ordering with a tail light install, please allow 1-2 days for install. Tail lights are installed by trimming the excess holding tabs in the rear, and the 22-LED length strip is adhered in with 3-4 small dabs of clear epoxy. This creates a strong hold that is reliable, and still allows full light transmission through the box window. More information in the link below.

This is a TORque box enclosure with screws.
If ordering with a tail light install, please allow 1-2 days for install. Tail lights are installed by trimming the excess holding tabs in the rear, and the 22-LED length strip is adhered in with 3-4 small dabs of clear epoxy. This creates a strong hold that is reliable, and still allows full light transmission through the box window. More information in the link below.

Installation information can be found in this article:

VESC [DIY] One Wheel Lights | Arduino | Code by Mitch Lustig — The Board Garage